By default, the CommuniGate Pro SNMP agent is not activated.
Use the WebAdmin Interface to configure the SNMP Module. Open the Services pages in the Settings realm, and open the SNMP page:
Log: Use this setting to specify what kind of information the SNMP agent should put in the Server Log. Usually you should use the Major or Problems (non-fatal errors) levels. But when you experience problems with the SNMP agent, you may want to set the Log Level setting to Low-Level or All Info: in this case protocol-level or link-level details will be recorded in the System Log as well.
The SNMP agent records in the System Log are marked with the SNMP tag. Please note that SNMP is a binary protocol, so all low-level data is presented in the hexadecimal form.
listener: Use this link to open the UDP Listener page and specify the port number and local network address for the SNMP agent, and access restrictions for that port. When the port number is set to 0, the SNMP agent is disabled. By default SNMP Manager programs send requests to the UDP port 161.
If your server computer is already running some other SNMP agent, you may want to specify a non-standard port number here and reconfigure your SNMP Manager software to use that port number.
Password: Use this setting to specify the SNMP "community name". The CommuniGate Pro SNMP agent accepts only those SNMP requests that contain the proper "community name" data.
Trap Password: This setting specifies an alternative SNMP "community name". The CommuniGate Pro SNMP agent accepts SNMP requests containing this "community name", and remembers the network (IP) addresses those requests have come from. The module then can send SNMP Traps to all remembered addresses.
Trap Protocol: This setting specifies the SNMP protocol version to use when sending SNMP Traps.